Table of Contents
Advertisement
Types of Usable Media
The following describes usable media size and method of handling.
Usable Media Size
Width
Max. Length
Max. printing width
Thickness
Roll outside diameter
Roll weight
Roll inside diameter
• Tape up or paste a weak adhesive on the end of the roll media.
• When the media size is small and adsorption holes are free, cover them on the table
with the same media or the thinner media and fix them by an adhesive tape so that any
printing trouble does not occur.
• When fixing by an adhesive tape, use a kind of drafting tape which does not remain any
paste on the adsorption plate.
• Set thickness of both the media and adhesive tape 2.0mm or less.
Cautions in Handling Media
Carefully observe the following when handling media.
• Expansion and contraction of media
Do not use leaf media immediately after unpacking.
The media can expand and contract due to room temperature and humid-
ity. The media have to be left in the atmosphere in which they are used for
30 minutes or more after unpacking.
• Curling of media
Leaf media should be flat or curled downward (swelled at the center) with
the printing surface facing up. Media curled upward may not be absorbed
to the table. When storing media that is easily curled, place them on a base
or pallet slightly smaller than the media area so that the media will be
curled downward during storage.
• When using the table
In order to maintain the absorption effect, block the absorption holes on the
table, which cannot be covered with media, with other media thinner than
those to be used. (
• Other notices
* Do not put anything on coated paper, or discoloration may occur.
* Do not use any leaf media which is curled and unable to adsorb. Fix the
Roll Media
Max. 640mm, Min. 180mm
According to the roll length
600mm x 500mm
0.02 to 0.2mm
Ø180 mm or less
25kg or less
3 inch
P.2-19)
media by taping up.
Max. 620mm, Min. 180mm
520mm
0.02 to 2.0mm
–
–
–
- 1-19 -
Leaf Media
Advertisement
Table of Contents
