Table of Contents
Advertisement
About UV light
•
Some UV light leaks from the openings
for media. UV light applied to your skin
or your eyes might cause inflammation
or skin cancer. Thought weak UV light
m i g h t c a u s e n o i n f l a m m a t i o n ,
repeated exposure to it may lead to
chronic disorders. Avoid minimize
getting UV light on your skin or eyes.
Impairment of eyes caused by UV light
•
may be:
Acute disorders ... Pain in eyes,
tearing, etc.
Chronic disorders ... Cataract, etc.
When UV light applies to you, take
protective measures such as gloves,
long-sleeve cloth, light-resistant mask,
attached light-resistant goggles, etc.
About cleaning
•
After using the unit for a long time,
foreign materials and dust may be
gathered on the conductive and
insulating parts, causing electric
leakage. Periodically clean such parts.
•
To clean the printer, use a vacuum
cleaner and not compressed air which
scatters foreign material and dust
which can cause the printer failures.
•
Do not use the printer in a place where
there is a possibility of being wet, or
electrical leakage may occur.
•
Electrical leakage, if it occurred, might
make workers get electric shocks and
cause fire.
•
In order to prevent accidents, be sure
to carry out periodic inspections and
replacements of components needing
periodic replacement.
CAUTION
About hot parts
•
The UV lamp and the interior of the
UV irradiation device will have a very
high temperature. When carrying out
maintenance, turn off the lamp and wait
until it is sufficiently cool.
Some parts on the outside of the
•
printer get very hot.
These parts have warning labels. Wait
until these parts have cooled before
touching them.
•
When you may touch the printer when
it is very hot, wear insulated gloves.
About firing and smoking
•
Touching hot parts such as the UV
lamp with combustible materials may
cause fire or the material to smoke.
•
After the printer is used for a long time,
screws and other fasteners on the
conductive parts may loosen and
cause a fire or smoke. Periodically
tighten such fasteners.
After the printer is used for a long time,
•
foreign materials or dust gathered on
the stabilizer or other parts and cause
electrical leakage or insulation
deterioration resulting in a fire or
smoking. Periodically clean these
parts and measurements of the
insulation resistance.
This printer is not explosion proof. Do
•
not use in an atmosphere where it is
exposed to hazardous or flammable
materials.
•
If the printer is smoking or sparking, or
has an abnormal order, turn it OFF
immediately and contact MIMAKI.
- xv -
Advertisement
Table of Contents
