Printing An Image From Source Data; Starting The Printing Operation; Interruption Of Printing - MIMAKI UJF-7151 plus Operation Manual

Chapter 2 Basic Operation
Printing an image from
source data

Starting the printing operation

• If the temperature of the head has not reached the
predetermined value, a message is displayed.
Printing is not allowed in such cases. When the
display is disappeared, printing can be started.
• Data transmission is allowed even if errors are
displayed. Printing is started after the display is
disappeared.
Set the media. (
1
• When you set the FAN MODE setting (
13) to "MANUAL", press [SEL] and [FUNC1]
(REMOTE) depending on the use and vacuum
the media.
Press the
2
• The machine goes in the remote mode and data
from the computer can be received.
• The table height (including the vacuum table and
the table spacer) is displayed.
Transmit data to be drawn from the
3
computer.
• Printing conditions are displayed.
• As for the data transmission method, see the
instruction manual of the output software.
Resolution
600 /900 /1200 /1800 /2400 DPI
The length of media printed
REMOTE
600x900 VD
12p / Uni / Hi / LT 151.5mm
PRE
0 0mm
Scanning speed
Scan direction
Uni : Unidirectional
Number of passes
• Use LT mode when you need more
flexibility.
• When LT mode is enabled, UV light
intensity is adjusted. Please check the
printing status.
Start printing.
4
• The printing origin is not changed after completion
of the printing.
2-8
P.2-4)
(REMOTE) in local.
Height of the current table
PRINT POST
0 0mm 40° /50°
LT mode setting
LT : LT mode active
Hi : Double speed
Taking out the media after completion of
5
printing.
(1) When you made vacuum ON, Press the
[FUNC1] (VACUUM)
OFF.
(2) Remove the media.
• During printing, media may be heated by the LED
UV and raised, causing printing to be interrupted.
In this case, set new media and restart printing.
P.3-

Interruption of printing

To interrupt printing, stop the printing operation and erase
the received data from the machine.
Press
1
• Printing operation stops.
• When data is transmitted from the computer, the
computer stops transmission of data.
Press the
2
• "DATA CLEAR" appears on the lower line of the
display.
Press
3
Press the
4
• Received data is erased and the machine returns
to the local mode. The table moves to the
evacuation position.
to turn the adsorption
• When you use the vacuum function of
the vacuum table to draw, turn OFF the
vacuum when printing has been
completed.
(LOCAL) while printing.
• To restart printing, press the [FUNC3]
(REMOTE).
key onece.
(DATACLEAR).
key.