Setting Event Mail Function - MIMAKI JV300-130 A Operation Manual

Press , and press the
6
• "DHCP" will be selected.
Press
7
press the
• Set value : ON/ OFF
• When it is ON, the IP address given by the DHCP
server is used.
Press , and press the
8
• "AutoIP" will be selected.
Press
9
press the
• Set value : ON/ OFF
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
Press , and press the
10
• "IP ADDRESS" will be selected.
Press
11
press the
• Set value : ON/ OFF
• Both of DHCP and AutoIP is OFF, you can set IP
Address. For other than above, proceed to the
Step 14.
Press the
12
• The setting items DEFAULT GATEWAY, DNS
ADDRESS and SUBNET MASK will be displayed.
• Both of DHCP and AutoIP is OFF, you can set
DEFAULT GATEWAY/ DNS ADDRESS/ SUBNET
MASK. For other than above, proceed to the Step
14.
Press the several times to select
13
setting item, and press the
Press
14
press the
Press the
15
to end the setting.
• To reflect network setting, once turn off the power
supply and then turn it on again.
key.
to select a set value, and
key.
key.
to select a set value, and
key.
key.
to select a set value, and
key.
key .
key.
to select a set value, and
key.
key several times
Chapter 3 Machine setting

Setting event mail function

Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (https://mimaki.com/download/).
• Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.
Enable the event mail function
Press the
1
times)
• MACHINE SETUP MENU will be displayed.
Press the
2
Press
3
and press the
Press the
4
• "MAIL DELIVERY" will be selected.
Press
5
press the
Press the
6
to end the setting.
(MENU) (twice
key in LOCAL.
(>>) .
to select "EVENT MAIL",
key.
key.
to select "ON", and
key.
key several times
1
2
3
4
5
6
3-15