GeoVision GV-IPCAM User Manual page 313

To apply QoS to GV-IPCAM H.264, all network routers must support QoS
and QoS must be enabled on these devices. To enable the QoS on GV-
IPCAM H.264, enter a Differentiated Services Code Point (DSCP) value.
This value is a field in an IP packet that enables different levels of services
for the network traffic. When the video stream from GV-IPCAM H.264
reaches a router, the DSCP value will tell the router what service level to
be applied, e.g. the bandwidth amount. This value ranges from 0 to 63 in
decimal format. The default value is 0, meaning QoS is disabled.
[Network Connection Check Settings] The camera checks for Internet
connection, and reboots when it is disconnected from the Internet. This
function is enabled by default.
Note: If you do not intend to connect the camera to the network,
disable this function to prevent automatic reboot.
Administrator Mode
16
287