Limited Ip Multicast Address - D-Link xStack DGS-3600 Series Cli Manual

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
The Limited IP Multicast command allows the administrator to permit or deny access to a port or range of ports by specifying a range
of multicast addresses. The Limited IP Multicast Commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
config limited multicast address
delete limited multicast address
show limited multicast address
create multicast_range
delete multicast_range
show multicast_range
config limited_multicast_addr
show limited_multicast_addr
Each command is listed in detail in the following sections.
config limited multicast address
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the limited multicast address on ports 1-3:
DGS-3627:5#config limited multicast address 1-3 from 224.1.1.1 to 224.1.1.2 access
permit state enable
Command: config limited multicast address 1-3 from 224.1.1.1 to 224.1.1.2 access
Parameters
<portlist> {from <multicast_ipaddr> to <multicast_ipaddr>
access [permit | deny] | state [enable | disable]}
[all | <portlist>]
{<portlist>}
<range_name 32> from <multicast_ipaddr> to <multicast_ipaddr>
[<range_name 32> | all]
{<range_name 32>}
ports <portlist> {add multicast_range <range_name 32> | delete
multicast_range [<range_name 32> | all] | {access [permit | deny] |
state [enable | disable]}]
{ports <portlist>}
Used to configure limited IP multicast address range.
config limited multicast address <portlist> {from
<multicast_ipaddr> to <multicast_ipaddr> access [permit | deny] |
state [enable | disable]}
The config limited multicast address command allows the user to
configure the multicast address range, access level, and state.
<portlist> - A port or range of ports to config the limited multicast
address. The beginning and end of the port list range are separated by
a dash. Non-contiguous portlist entries are separated by a comma.
(ex:1-3,7-9)
from - Enter the lowest multicast IP address of the range.
to - Enter the highest multicast IP address of the range.
access - Use the access field to either permit or deny to limit or grant
access to a specified range of Multicast addresses on a particular port
or range of ports.
state - This parameter allows the user to enable or disable the limited
multicast address range on a specific port or range of ports.
Only administrator-level and operator-level users can issue this
command. This command is used as a backwards compatible
command for legacy devices and firmware.
L IP M
IMITED
204
27
A
ULTICAST DDRESS