D-Link xStack DGS-3600 Series Cli Manual page 115

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config scheduling
Restrictions
Example usage:
To configure the traffic scheduling mechanism for each queue:
DGS-3627:5# config scheduling 0 max_packet 12
Command: config scheduling 0 max_packet 12
Success.
DGS-3627:5#
show scheduling
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current scheduling configuration:
config 802.1p user_priority
Purpose
Syntax
Description
Only administrator-level and operator-level users can issue this command.
Used to display the currently configured traffic scheduling on the Switch.
show scheduling
The show scheduling command will display the current traffic
scheduling mechanisms in use on the Switch.
None.
None.
DGS-3627:5#show scheduling
Command: show scheduling
QOS Output Scheduling
Class ID MAX. Packets
----------- --------------------
Class-0 1
Class-1 2
Class-2 3
Class-3 4
Class-4 5
Class-5 6
Class-6 7
DGS-3627:5#
Used to map the 802.1p user priority of an incoming packet to one of the
seven hardware queues available on the Switch.
config 802.1p user_priority <priority 0-7> <class_id 0-6>
This command allows users to configure the method that the Switch will map
an incoming packet, based on its 802.1p user priority, to one of the seven
available hardware priority queues on the Switch.
The Switch's default is to map the following incoming 802.1p user priority
values to the eight hardware priority queues:
802.1p Hardware Queue
0 2
1 0
Remark
Mid-low
Lowest
112