D-Link xStack DGS-3600 Series Cli Manual page 38

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
disable snmp linkchange_traps
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable SNMP linkchange traps:
DGS-3627:5#disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DGS-3627:5#
config snmp linkchange_traps
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To configure SNMP linkchange traps on every port:
DGS-3627:5#
Used to disable SNMP link change traps on the Switch.
disable snmp linkchange_traps
This command is used, in conjunction with the enable snmp
linkchange_traps command above, to enable and disable SNMP
linkchange traps on the Switch.
None.
Only administrator-level and operator-level users can issue this
command.
Used to configure SNMP link change traps on the Switch.
config snmp linkchange_traps ports
[all|<portlist>][enable|disable]
This command is used to configure SNMP linkchange traps on the
Switch.
all − Configure all ports on the Switch.
<portlist> - Specifies a port or range of ports to be configured. The
beginning and end of the port list range are separated by a dash.
Non-contiguous portlist entries are separated by a comma. (ex: 1-
3,7-9).
enable | disable – Use these parameters to enable or disable
SMMP linkchange traps for the switch.
Only administrator-level and operator-level users can issue this
command.
DGS-3627:5#config snmp linkchange_traps ports all enable
Command: enable snmp linkchange_traps all enable
Success.
DGS-3627:5#
35