Igmp Snooping Commands - D-Link xStack DGS-3600 Series Cli Manual

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config igmp_snooping
config igmp_snooping querier
config router_ports
config router_ports_forbidden
enable igmp_snooping
show igmp_snooping
disable igmp_snooping
show igmp snooping group
show router_ports
show igmp_snooping forwarding
create igmp_snooping multicast_vlan
config igmp_snooping multicast_vlan
delete igmp_snooping multicast_vlan
show igmp_snooping multicast_vlan
config igmp_snooping multicast_vlan_group
show igmp_snooping multicast_vlan_group
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose
Syntax
Description
Parameters
Parameters
[vlan <vlan_name 32> | all] {host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450> | leave_timer <sec 1-
16711450> | state [enable | disable] | fast_leave [enable |
disable]}
[vlan <vlan_name 32> | all] {query_interval <sec 1-65535> |
max_response_time <sec 1-25> | robustness_variable <value 1-
255> | last_member_query_interval <sec 1-25> | state [enable |
disable]}
<vlan_name 32> [add | delete] <portlist>
<vlan_name 32> [add | delete] <portlist>
{forward_mcrouter_only}
{vlan <vlan_name 32>}
{forward_mcrouter_only}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>} {[static | dynamic| forbidden]}
{vlan <vlan_name 32>}
<vlan_name 32> <vlanid 2-4094>
<vlan_name 32> {member_port <portlist> | source_port <portlist>
| state [enable | disable] | replace_source_ip <ipaddr>
<vlan_name 32>
{<vlan_name 32>}
<vlan_name 32> [add multicast_range <range_name 32> | delete
multicast_range [<range_name 32> | all]]
{<vlan_name 32>}
Used to configure IGMP snooping on the Switch.
config igmp_snooping [vlan <vlan_name 32> | all] {host_timeout <sec 1-
16711450> | router_timeout <sec 1-16711450> | leave_timer <sec 1-
16711450> | state [enable | disable]} | fast_leave [enable | disable]}
This command allows users to configure IGMP snooping on the Switch.
vlan <vlan_name 32> − The name of the VLAN for which IGMP snooping is to
be configured.
host_timeout <sec 1-16711450> − Specifies the maximum amount of time a
host can be a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount of time a
route can be a member of a multicast group without the Switch receiving a
IGMP S
165
23
C
NOOPING OMMANDS