D-Link xStack DGS-3600 Series Cli Manual page 157

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
show ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display IP interface settings.
DGS-3627:5#show ipif System
Command: show ipif System
IP Interface Settings
IP Interface
VLAN Name
Interface Admin State : Enabled
IPv4 Address
DGS-3627:5#
enable ipif_ipv6_link_local_auto
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the IP interface IPv6 link-local settings .
DGS-3627:5#enable ipif_ipv6_link_local_auto all
Command:enable ipif_ipv6_link_local_auto all
Success.
DGS-3627:5#
Used to display the configuration of an IP interface on the Switch.
show ipif {<ipif_name 12>}
This command will display the configuration of an IP interface on the
Switch.
<ipif_name 12> − The name created for the IP interface to be viewed.
None.
: System
: default
: 10.53.13.199/8 (Manual) Primary
NOTE: In the IP Interface Settings table shown above, the Secondary field
will have two displays. FALSE denotes that the IP interface is a primary IP
interface while TRUE denotes a secondary IP interface.
Used to enable the autoconfiguration of the link local address when no
IPv6 address is configured.
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
This command will automatically create an IPv6 link local address for
the Switch if no IPv6 address has previously been configured.
<ipif_name 12> − The name of the IP interface that will be given an
IPv6 link local address.
all – Entering this command will assign an IPv6 link-local address to all
configured IP Interfaces currently configured on the switch.
Only administrator-level and operator-level users can issue this
command.
154