D-Link xStack DGS-3600 Series Cli Manual page 342

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config ospf host_route
Restrictions
Usage example
To configure an OSPF host route:
DGS-3627:5#config ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Command: config ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Success.
DGS-3627:5#
show ospf host_route
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To display the current OSPF host route table:
create ospf aggregation
Purpose
Syntax
Description
Parameters
Only administrator-level and operator-level users can issue this command.
Used to display the current OSPF host route table.
show ospf host_route {<ipaddr>}
This command will display the current OSPF host route table.
<ipaddr> − The IP address of the host.
None.
DGS-3627:5#show ospf host_route
Command: show ospf host_route
Host Address Metric
--------------- ---------------
10.48.73.21 2
10.48.74.122 1
Total Entries: 2
DGS-3627:5#
Used to configure OSPF area aggregation settings.
create ospf aggregation <area_id> <network_address> lsdb_type
[summary {advertise [enable | disable]} | nssa_ext {advertise [enable
| disable]}]
This command is used to create an OSPF area aggregation.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<network_address> − The 32-bit number in the form of an IP address that
uniquely identifies the network that corresponds to the OSPF Area.
lsdb_type − The type of address aggregation. The user has two choices
for the LSDB type:
•
summary – Choosing this LSDB type will summarize routes that
Area_ID
-----------
10.1.1.1
10.1.1.1
339