D-Link xStack DGS-3600 Series Cli Manual page 17

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config serial_port
Parameters
Restrictions
Example usage:
To configure baud rate:
enable clipaging
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable pausing of the screen display when the show command output reaches the end of the page:
disable clipaging
Purpose
baud_rate [9600 | 19200 | 38400 | 115200] − The serial bit rate that will be
used to communicate with the management host. There are four options:
9600, 19200, 38400, and 115200.
never − No time limit on the length of time the console can be open with
no user input.
2_minutes − The console will log out the current user if there is no user
input for 2 minutes.
5_minutes − The console will log out the current user if there is no user
input for 5 minutes.
10_minutes − The console will log out the current user if there is no user
input for 10 minutes.
15_minutes − The console will log out the current user if there is no user
input for 15 minutes.
Only administrator-level and operator-level users can issue this
command.
DGS-3627:5#config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Success.
DGS-3627:5#
Used to pause the scrolling of the console screen when the show
command displays more than one page.
enable clipaging
This command is used when issuing the show command which
causes the console screen to rapidly scroll through several pages.
This command will cause the console to pause at the end of each
page. The default setting is enabled.
None.
Only administrator-level and operator-level users can issue this
command.
DGS-3627:5#enable clipaging
Command: enable clipaging
Success.
DGS-3627:5#
Used to disable the pausing of the console screen scrolling at the
14