D-Link xStack DGS-3600 Series Cli Manual page 242

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config access_profile profile_id (ipv6)
{time_range <range_name 32>} – Choose this parameter and enter the name of the Time
Range settings that has been previously configured using the config time_range command.
This will set specific times when this access rule will be enabled or disabled on the Switch.
delete access_id <value 1-128> − Use this command to delete a specific rule from the IPv6
profile. Up to 128 rules may be specified for the IPv6 access profile.
Restrictions Only administrator-level and operator-level users can issue this command.
Example usage:
To configure a previously created access profile based on IPv6 classification:
DGS-3627:5#config access_profile profile_id 4 add access_id 1 ipv6
class 1 flowlabel 0xABCD port 4 deny
Command: config access_profile profile_id 4 add access_id 1 ipv6
class 1 flowlabel 0xABCD port 4 deny
Success.
DGS-3627:5#
delete access_profile
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the access profile with a profile ID of 1:
DGS-3400:4# delete access_profile profile_id 1
Command: delete access_profile profile_id 1
Success.
DGS-3400:4#
show access_profile
Purpose
Syntax
Description
Parameters
Used to delete a previously created access profile.
delete access_profile [profile_id <value 1-14> | all]
The delete access_profile command is used to delete a previously
created access profile on the Switch.
profile_id <value 1-14> − Enter an integer between 1 and 14 that is
used to identify the access profile that will be deleted with this
command. This value is assigned to the access profile when it is
created with the create access_profile command.
all – Use this parameter to delete all created access profiles on the
Switch.
Only administrator-level and operator-level users can issue this
command.
Used to display the currently configured access profiles on the Switch.
show access_profile {profile_id <value 1-14>}
The show access_profile command is used to display the currently configured
access profiles.
profile_id <value 1-14> − Enter an integer between 1 and 14 that is used to
identify the access profile that will be viewed with this command. This value is
assigned to the access profile when it is created with the create access_profile
239