D-Link xStack DGS-3600 Series Cli Manual page 419

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
show sim
Parameters
Restrictions
Example usage:
To show the SIM information in detail:
DGS-3627:5#show sim
Command: show sim
Group Name
SIM Version
Firmware Version : 2.40.B19
Device Name
MAC Address
Capabilities
Platform
SIM State
Role State
Discovery Interval : 30 sec
Holdtime
DGS-3627:5#
To show the candidate information in summary, if the candidate ID is specified:
MAC Address - Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or Layer
3 (L3).
Platform – Switch Description including name and model number.
SIM State –Displays the current Single IP Management State of the
Switch, whether it be enabled or disabled.
Role State – Displays the current role the Switch is taking, including
Commander, Member or Candidate. A Stand-alone switch will always
have the commander role.
Discovery Interval - Time in seconds the Switch will send discovery
packets out over the network.
Hold time – Displays the time in seconds the Switch will hold
discovery results before dropping it or utilizing it.
candidates <candidate_id 1-100> - Entering this parameter will
display information concerning candidates of the SIM group. To view
a specific candidate, include that candidate's ID number, listed from 1
to 100.
members <member_id 1-32> - Entering this parameter will display
information concerning members of the SIM group. To view a specific
member, include that member's id number, listed from 1 to 32.
group {commander_mac <macaddr>} - Entering this parameter will
display information concerning the SIM group. To view a specific
group, include the commander's MAC address of the group.
neighbor – Entering this parameter will display neighboring devices of
the Switch. A SIM neighbor is defined as a switch that is physically
connected to the Switch but is not part of the SIM group. This screen
will produce the following results:
•
Port – Displays the physical port number of the commander
switch where the uplink to the neighbor switch is located.
•
MAC Address – Displays the MAC Address of the neighbor
switch.
•
Role – Displays the role(CS, CaS, MS) of the neighbor
switch.
Only administrator-level and operator-level users can issue this
command.
: default
: VER-1.61
:
: 00-10-20-33-45-00
: L3
: DGS-3627 L3 Switch
: Disabled
: Candidate
: 100 sec
416