Limited Ip Multicast Address - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
L IP M
IMITED
The Limited IP Multicast command allows the administrator to permit or deny access to a port or range of ports by
specifying a range of multicast addresses. The Limited IP Multicast Commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following table.
Command
create mcast_filter_profile profile_id
config mcast_filter_profile
delete mcast_filter_profile profile_id
delete mcast_filter_profile profile_name
show mcast_filter_profile
config limited_multicast_addr
show limited_multicast_addr
config max_mcast_group
show max_mcast_group
Each command is listed, in detail, in the following sections.
create mcast_filter_profile profile_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a multicast filter profile:
DES-3528:admin# create mcast_filter_profile profile_id 2 profile_name MOD
Command: create mcast_filter_profile profile_id 2 profile_name MOD
Success.
DES-3528:admin#
config mcast_filter_profile
Purpose
Syntax
Description
Parameters
A
ULTICAST
Parameters
<value 1-24> profile_name <name 1-32>
[profile_id < value 1-24> | profile_name <name 1-32> ] { profile_name
<name 1-32> | [add | delete ] <mcast_address_list>} (1)
[<value 1-24> | all]
<name 1-32>
{[profile_id <value 1-24> | profile_name <name 1-32>]}
[ports <portlist> | vlanid <vidlist>] {[add | delete] [profile_id <value 1-24>
| profile_name <name 1-32> ] | access [permit | deny]} (1)
[ports <portlist> | vlanid <vidlist>]
[ports <portlist> | vlanid <vidlist>] {max_group [<value 1-1024> | infinite]
| action [drop | replace]} (1)
[ports <portlist> | vlanid <vidlist>]
Used to create a multicast address profile.
create mcast_filter_profile profile_id <value 1-24> profile_name <name 1-32>
This command configures a multicast address profile. Mutliple ranges of multicast addresses
can be defined in the profile.
profile_id - Specifies the ID of the profile. The range is 1 to 24.
<name 1-32> − Provides a meaningful description for the profile.
Only Administrator and Operator and Power-User-level users can issue this command.
Used to add or delete a range of multicast addresses to the profile.
config mcast_filter_profile [profile_id < value 1-24> | profile_name <name 1-32> ] {
profile_name <name 1-32> | [add | delete ] <mcast_address_list>} (1)
This command allows the user to add or delete a range of multicast IP addresses previously
defined.
profile_id − ID of the profile. The range is 1 to 24.
profile_name − Provides a meaningful description for the profile.
mcast_address_list − List of the multicast addresses to be put in the profile.
DDRESS
155