D-Link xStack DGS-3600 Series Cli Manual page 291

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config vrrp vrid
Restrictions
Example usage:
To configure a VRRP entry:
DGS-3627:5#config vrrp vrid 1 ipif Zira state enable priority 100 advertisement_interval 2
Command: config vrrp vrid 1 ipif Zira state enable priority 100 advertisement_interval 2
Success.
DGS-3627:5#
config vrrp ipif
Purpose
Syntax
Description
Parameters
router. A true entry, along with having the backup router's priority set
higher than the masters priority, will set the backup router as the
Master router. A false entry will disable the backup router from
becoming the Master router. This setting must be consistent with all
routers participating within the same VRRP group. The default
setting is true.
critical_ip <ipaddr> - Enter the IP address of the physical device that
will provide the most direct route to the Internet or other critical
network connections from this virtual router. This must be a real IP
address of a real device on the network. If the connection from the
virtual router to this IP address fails, the virtual router will be disabled
automatically. A new master will be elected from the backup routers
participating in the VRRP group. Different critical IP addresses may
be assigned to different routers participating in the VRRP group, and
can therefore define multiple routes to the Internet or other critical
network connections.
critical_ip_state [enable | disable] – This parameter is used to enable
or disable the critical IP address entered above. The default is
disable.
Only administrator-level and operator-level users can issue this
command.
To configure the authentication type for the VRRP routers of an IP
interface.
config vrrp ipif <ipif_name 12> [authtype [none | simple
authdata <string 8> | ip authdata <string 16>]
This command is used to set the authentication type for the VRRP
routers of an IP interface.
ipif <ipif_name 12> - Enter the name of a previously configured IP
interface for which to configure the VRRP entry. This IP interface
must be assigned to a VLAN on the Switch.
authtype – Specifies the type of authentication used. The authtype
must be consistent with all routers participating within the VRRP
group. The user may choose between:
•
none – Entering this parameter indicates that VRRP
protocol exchanges will not be authenticated.
•
simple authdata <string 8> - This parameter, along with an
alphanumeric string of no more than eight characters, to
set a simple password for comparing VRRP message
packets received by a router. If the two passwords are not
exactly the same, the packet will be dropped.
ip authdata <string 16> - This parameter will require the user to set
288