D-Link xStack DGS-3600 Series Cli Manual page 377

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
show authen application
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the login and enable method list for all applications on the Switch:
DGS-3627:5#show authen application
Command: show authen application
Application
----------------- -------------------------- ---------------------------
Console
Telnet
SSH
HTTP
DGS-3627:5#
create authen server_host
Purpose
Syntax
Description
Parameters
DGS-3627:5#config authen application http login default
Command: config authen application http login default
Success.
DGS-3627:5#
Used to display authentication methods for the various applications on
the Switch.
show authen application
This command will display all of the authentication method lists (login,
enable administrator privileges) for Switch configuration applications
(console, Telnet, SSH, web) currently configured on the Switch.
None.
None.
Login Method List Enable Method List
default
DLee
default
default
Used to create an authentication server host.
create authen server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius] {port <int 1-65535> | key [<key_string 254> | none]
| timeout <int 1-255> | retransmit < 1-255>}
This command will create an authentication server host for the
TACACS/XTACACS/TACACS+/RADIUS security protocols on the
Switch. When a user attempts to access the Switch with authentication
protocol enabled, the Switch will send authentication packets to a remote
TACACS/XTACACS/TACACS+/RADIUS server host on a remote host.
The TACACS/XTACACS/TACACS+/RADIUS server host will then verify
or deny the request and return the appropriate message to the Switch.
More than one authentication protocol can be run on the same physical
server host but, remember that TACACS/XTACACS/TACACS+/RADIUS
are separate entities and are not compatible with each other. The
maximum supported number of server hosts is 16.
server_host <ipaddr> - The IP address of the remote server host to add.
protocol – The protocol used by the server host. The user may choose
one of the following:
tacacs – Enter this parameter if the server host utilizes the
default
default
default
default
374