D-Link xStack DGS-3600 Series Cli Manual page 363

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config wac user
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a WAC user on the Switch.
DGS-3627:5#config wac user Peter vlan Chandler
Command: config wac user Peter vlan Chandler
Success.
DGS-3627:5#
show wac user
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the parameters for the WAC user:
DGS-3627:5#show wac user
Command: show wac user
Current Accounts:
Username
---------------
ctsnow
Total Entries : 1
DGS-3627:5#
user on the Switch.
config wac user <username 15> vlan <vlan_name 32>
This command is used to configure a previously created Web-based
Access Control user on the Switch.
<username 15> - Enter a username of up to 15 alphanumeric
characters used to authenticate users trying to access the network via
the Switch. This username must be identical to the one the user
enters to access the Web-based Access Control for the Switch.
vlan <vlan_name 32> - Enter the VLAN name of the VLAN this user
will be placed in, once authenticated, if a change in VLANs is desired.
Only administrator-level users can issue this command.
Used to display the parameters for a previously created Web-based
Access Control user on the Switch.
show wac user
This command is used to display the parameters for a previously
created Web-based Access Control user on the Switch.
None.
Only administrator-level users can issue this command.
VLAN name
----------------
Tiberius
360