D-Link xStack DGS-3600 Series Cli Manual page 404

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
config lldp notification _interval
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To change the notification interval to 10 seconds:
config lldp ports notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To change the SNMP notification state of ports 1 to 5 to enable:
Used to configure the timer of the notification interval for sending
notification to configured SNMP trap receiver(s).
config lldp notification_interval <sec 5 – 3600 >
Globally change the interval between successive LLDP change
notifications generated by the switch.
notification_interval – The range is from 5 seconds to 3600 seconds.
The default setting is 5 seconds.
Only administrator-level and operator-level users can issue this
command.
DGS-3627:5#config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DGS-3627:5#
Used to configure each port for sending notification to configured
SNMP trap receiver(s).
config lldp ports [<portlist>|all] notification [enable | disable]
Enable or disable each port for sending changes notification to
configured SNMP trap receiver(s) if an LLDP data change is detected
in an advertisement received on the port from an LLDP neighbor. The
definition of change includes new available information, information
timeout, information update. And the changed type includes any data
update /insert/remove.
<portlist>- Use this parameter to define ports to be configured.
all – Use this parameter to set all ports in the system.
notification – Enables or disables the SNMP trap notification of LLDP
data changes detected on advertisements received from neighbor
devices. The default notification state is disabled.
Only administrator-level and operator-level users can issue this
command.
DGS-3627:5#config lldp ports 1:1-1:5 notification enable
Command: config lldp ports 1:1-1:5 notification enable
Success.
DGS-3627:5#
401