D-Link xStack DGS-3600 Series Cli Manual page 388

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3627:5#config ssh authmode password enable
Command: config ssh authmode password enable
Success.
DGS-3627:5#
show ssh authmode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the current authentication mode set on the Switch:
config ssh server
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
Used to display the SSH authentication mode setting.
show ssh authmode
This command will allow users to display the current SSH
authentication set on the Switch.
None.
None.
DGS-3627:5#show ssh authmode
Command: show ssh authmode
The SSH authmode:
---------------------------------------------------------------
Password : Enabled
Publickey : Enabled
Hostbased : Enabled
DGS-3627:5#
Used to configure the SSH server.
config ssh server {maxsession <int 1-8> | timeout <sec 120-
600> | authfail <int 2-20> | rekey [10min | 30min | 60min | never]
This command allows you to configure the SSH server.
maxsession <int 1-8> - Allows the user to set the number of users
that may simultaneously access the Switch. The default setting is 8.
contimeout <sec 120-600> - Allows the user to set the connection
timeout. The user may set a time between 120 and 600 seconds.
The default is 300 seconds.
authfail <int 2-20> - Allows the administrator to set the maximum
number of attempts that a user may try to logon utilizing SSH
authentication. After the maximum number of attempts is exceeded,
the Switch will be disconnected and the user must reconnect to the
Switch to attempt another login.
rekey [10min |30min | 60min | never] - Sets the time period that the
Switch will change the security shell encryptions.
Only administrator-level and operator-level users can issue this
command.
385