D-Link xStack DGS-3600 Series Cli Manual page 301

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Entering the Type combination − Internal, ExtType_1, ExtType_2 is functionally equivalent to All. Entering the combination
ExtType_1, ExtType_2 is functionally equivalent to External. Entering the combination Internal, External is functionally
equivalent to All.
Entering the metric 0 specifies transparency.
Example usage:
To add route redistribution settings
config route redistribute dst ospf src
Purpose
Syntax
Description
Parameters
Restrictions
Routing information source − RIP: the Static Route table, and the Local interface routing information. Routing information will be
redistributed to OSPF. The following table lists the allowed values for the routing metrics and the types (or forms) of the routing
information that will be redistributed.
DGS-3627:5#create route redistribute dst rip src ospf all metric 2
Command: create route redistribute dst rip src ospf all metric 2
Success.
DGS-3627:5#
Used configure route redistribution settings for the exchange of RIP
routes to OSPF routes on the Switch.
config route redistribute dst ospf src [static | rip | local] {mettype [1
| 2] | metric <value 0-16777214>}
Route redistribution allows routers on the network − that are running
different routing protocols to exchange routing information. This is
accomplished by comparing the routes stored in the various router's
routing tables and assigning appropriate metrics. This information is then
exchanged among the various routers according to the individual router's
current routing protocol. The switch can redistribute routing information
between the OSPF and RIP routing protocols to all routers on the
network that are running OSPF or RIP. Routing information entered into
the Static Routing Table on the local switch is also redistributed.
src [static | rip | local] − Allows the selection of the protocol of the source
device.
mettype − allows the selection of one of the methods for calculating the
metric value.
•
Type - 1 calculates the metric (for RIP to OSPF) by adding the
destination's interface cost to the metric entered in the Metric field.
•
Type - 2 uses the metric entered in the Metric field without change.
This field applies only when the destination field is OSPF.
metric <value 0-16777214> − Allows the entry of an OSPF interface cost.
This is analogous to a Hop Count in the RIP routing protocol.
Only administrator-level and operator-level users can issue this
command.
Route Source
RIP
Static
Local
Metric
0 to 16777214
0 to 16777214
0 to 16777214
298
Metric Type
mettype 1
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2