Network Monitoring Commands - D-Link xStack DGS-3600 Series Cli Manual

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
clear attack_log
show attack_log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
config system_severity
show system_severity
config log_save_timing
show log_save_timing
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Parameters
<portlist>
<portlist>
[ports | cpu]
{ports <portlist>}
{index <value_list> }
{[unit <unit_id 1-12> | all]}
{unit <unit_id 1-12>} {index <value_list>}
<index 1-4> {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr> | state [enable | disable]}
[all | <index 1-4>] [severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr> | state [enable | disable]]
[<index 1-4> | all]
{<index 1-4>}
[trap | log | all] [critical | warning | information]
[time_interval <min 1-65535> | on_demand | log_trigger]
Used to display statistics about the packets sent and received by the Switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and received by
ports specified in the <portlist>.
<portlist> − Specifies a port or range of ports to be displayed. The beginning and
end of the port list range are separated by a dash.
None.
N M
ETWORK ONITORING
71
10
C
OMMANDS