D-Link xStack DGS-3600 Series Cli Manual page 85

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3627:5#config syslog host all facility local0
Command: config syslog host all facility local0
Success.
DGS-3627:5#
delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured syslog host:
DGS-3627:5#delete syslog host 4
Command: delete syslog host 4
Success.
DGS-3627:5#
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show Syslog host information:
DGS-3627:5#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address
-------
1
Used to remove a syslog host, that has been previously configured, from the
Switch.
delete syslog host [<index 1-4> | all]
The delete syslog host command is used to remove a syslog host that has
been previously configured from the Switch.
<index 1-4> − Specifies that the command will be applied to an index of hosts.
There are four available indexes, numbered 1 through 4.
all − Specifies that the command will be applied to all hosts.
Only administrator-level and operator-level users can issue this command.
Used to display the syslog hosts currently configured on the Switch.
show syslog host {<index 1-4>}
The show syslog host command is used to display the syslog
hosts that are currently configured on the Switch.
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
None.
Severity
--------------- --------------
10.1.1.2 All
Facility UDP port Status
-------- --------
Local0 514 Disabled
82
--------