D-Link xStack DGS-3600 Series Cli Manual page 208

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
permit state enable
Success.
DGS-3627:5#
delete limited multicast address
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the limited multicast address on ports 1-3:
show limited multicast address
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the limited multicast address on ports 1-2:
Used to delete Limited IP multicast address range.
delete limited multicast address [all | <portlist>]
The delete limited multicast address command allows the user to
delete all multicast address ranges or a selected range based on
what port or ports the range has been assigned to.
all - Allows the user to delete all limited multicast addresses that
have been configured on the Switch.
<portlist> - Allows the user to delete only those multicast address
ranges that have been assigned to a particular port or range of ports.
The beginning and end of the port list range are separated by a
dash. Non-contiguous portlist entries are separated by a comma.
(ex: 1-3,7-9)
Only administrator-level and operator-level users can issue this
command. This command is used as a backwards compatible
command for legacy devices.
DGS-3627:5#delete limited multicast address 1-3
Command: delete limited multicast address 1-3
Success.
DGS-3627:5#
Used to show per-port limited IP multicast address range.
show limited multicast address {<portlist>}
The show limited multicast address command allows users to
show multicast address range by ports.
<portlist> A port or range of ports on which the limited multicast
address range to be shown has been assigned. The beginning and
end of the port list range are separated by a dash. Non-contiguous
portlist entries are separated by a comma. (ex: 1-3,7-9)
None. This command is used as a backwards compatible command
for legacy devices.
DGS-3627:5#show limited multicast address 1-2
Command: show limited multicast address 1-2
205