Master Eject Section; Master Eject Solenoid Adjustment - Ricoh C226 Service Manual

6. MASTER EJECT SECTION

6.1 MASTER EJECT SOLENOID ADJUSTMENT

Purpose: To ensure that master is ejected.
1. Open the master eject unit and remove the upper cover of the master
eject unit (4 screws).
2. Access "I/O Check Mode".
•
Use Output Check mode (SP131) No. 17.
3. Press the Print Start key to energize the master eject solenoid.
4. Confirm that the lower first eject rollers [A] touch to the drum surface and
also confirm that they are separated from the drum when the master eject
solenoid is de-energized.
5. If it is out of adjustment, loosen the screws [B] and adjust the mounting
position of the master eject solenoid [C].
6. After adjustment, retighten the screws [B].
NOTE: To easily confirm that the lower roller touch to the drum surface.
Wrap the drum with the blank paper. Check the paper for roller
marks.
SM
[C]
[B]
5-23
MASTER EJECT SECTION
[C]
[A]
[A]
C226