Matrix Sparsh VP110 User Manual page 58

To configure a static IPv4 address via phone user interface:
• Press Menu->Settings->Advanced Settings (password: 1234)->Network->WAN Port and press the
Enter soft key.
• Press to select IPv4 and press the Enter soft key.
• Press to select Static IP Client and press the Enter soft key.
• Enter the desired values in the IP Address, Subnet Mask, Default Gateway, Pri DNS and Sec DNS fields.
• Press the Save soft key to save the changes.
• Reboot the IP phone to apply the changes.
If you are using an xDSL modem for IPv4 network connection, you can connect your phone to the Internet
via PPPoE mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a PPP negotiation to
obtain the IP address. Contact your service provider for the PPPoE username and password.
PPPoE
PPPoE (Point-to-Point Protocol over Ethernet) is a network protocol used by Internet Service Providers (ISPs) to
provide Digital Subscriber Line (DSL) high speed Internet services. PPPoE allows an office or building-full of users
to share a common DSL connection to the Internet. PPPoE connection is supported by the IP phone Internet port.
Contact your ISP for the PPPoE user name and password.
Procedure
PPPoE can be configured using the configuration files or locally.
Configuration File
Local
50
<MAC>.cfg
Web User Interface
Phone User Interface
Configure PPPoE on the IP phone.
For more information, refer "Appendix
D ‐ Configuration Parameters".
Configure PPPoE on the IP phone.
Navigate to:
http://<phoneIPAddress>/
servlet?p=network&q=load
Configure PPPoE on the IP phone.
Matrix SPARSH VP110 User Guide