Appendix D - Configuration Parameters; Setting Parameters In Configuration Files; Basic And Advanced Parameters - Matrix Sparsh VP110 User Manual

Appendix D - Configuration Parameters

This appendix describes configuration parameters in the configuration files for each feature. The configuration file
is <MAC>.cfg.

Setting Parameters in Configuration Files

You can set parameters in the configuration files to configure IP phones. The <MAC>.cfg file is stored on the
provisioning server. The IP phone checks for configuration files and looks for resource files when restarting the IP
phone. The <MAC>.cfg file stores configurations for a specific IP phone with that MAC address.

Basic and Advanced Parameters

DHCP
Parameter-
network.internet_port.type
Description
Format
Default Value
Range
Example
Parameter-
network.static_dns_enable
Description
Format
Default Value
Range
Example
356
Configuration File
<MAC>.cfg
Configures the Internet port type.
Note: If you change this parameter, the IP phone will
reboot to make the change take effect.
Integer
0
Valid values are:
0‐DHCP
1‐PPPoE
2‐Static IP Address
network.internet_port.type= 0
Configuration File
<MAC>.cfg
Enables or disables the phone to use manually
configured static IPv4 DNS when the parameter
"network.internet_port.type" is set to 0 (DHCP).
Note: If you change this parameter, the IP phone will
reboot to make the change take effect.
Boolean
0
Valid values are:
0-Disabled
1-Enabled
network.static_dns_enable= 0
Matrix SPARSH VP110 User Guide