Matrix Sparsh VP110 User Manual page 262

Reset
ATrans=xxx
BTrans=xxx
CALLEND
phonecfg=get[&accounts=x][&dnd=x][&fw=x]
• The variable value is not applicable to all events. For example, the variable value "MUTE" is only
applicable when the IP phone is during a call.
• When authentication is required, you must enter
"p=login&q=login&username=xxx&pwd=yyy&jumpto=URI&" before the variable "key". xxx refers to the
login user name and yyy refers to the login password.
For security reasons, IP phones do not receive and handle HTTP/HTTPS GET requests by default. You need to
specify the trusted IP address for action URI. When the IP phone receives a GET request from the trusted IP
address for the first time, the LCD screen prompts the message "Allow Remote Control?". You can specify one or
more trusted IP addresses on the IP phone, or configure the IP phone to receive and handle the URI from any IP
address.
Procedure
Specify the trusted IP address for action URI using the configuration files or locally.
Configuration File
254
Reset a phone.
Perform a semi‐attended/attended transfer to xxx.
Perform a blind transfer to xxx.
End a call.
Get firmware version, registration, DND or forward
configuration information.
The valid value of "x" is 0 or 1, 0 means you do not need to get
configuration information. 1 means you want to get
configuration information.
Note: The valid URI is:
http(s)://phone IP address/
servlet?phonecfg=get[&accounts=x][&dnd=x][&fw=x]
<MAC>.cfg
Specify the trusted IP address(es) for
sending the action URI to the IP
phone.
For more information, refer
"Appendix D ‐ Configuration
Parameters".
Matrix SPARSH VP110 User Guide