Matrix Sparsh VP110 User Manual page 477

################################################################################
#######
### Basic Network Parameter#################
#Network Settings##Configures the Internet port type.
#If you change any of the parameter, the IP phone will reboot to make the change
take effect.
#Configure the WAN port type; 0-DHCP(Default), 1-PPPoE, 2-Static IP Address.
network.internet_port.type = 2
#"network.static_dns_enable" Enables or disables the phone to use manually
configured static IPv4 DNS when the parameter "network.internet_port.type" #is
set to 0 (DHCP).
network.static_dns_enable = 1
#Static Network Settings#
#network.ip_address_mode Configures the IP address mode.IP phones support using
the IPv4 address only,the IPv6 address only or both IPv4 and IPv6 addresses.
#0-IPv4(Default),1-IPv6,2-IPv4&IPv6
network.ip_address_mode=0
#Configures the IP address when the Internet port type is configured as Static IP
Address and the IP address mode is configured as IPv4 or IPv4&IPv6.
network.internet_port.ip = 192.168.153.57
#Configures the subnet mask when the Internet port type is configured as Static
IP Address and the IP address mode is configured as IPv4 or IPv4&IPv6.
network.internet_port.mask = 255.255.255.0
#Configures the default gateway when the Internet port type is configured as
Static IP Address and the IP address mode is configured as IPv4 or IPv4&IPv6.
network.internet_port.gateway = 192.168.153.1
#Configures the primary DNS server when the Internet port type is configured as
Static IP Address and the IP address mode is configured as IPv4 or IPv4&IPv6.
network.primary_dns= 8.8.8.8
#Configures the secondary DNS server when the Internet port type is configured as
Static IP Address and the IP address mode is configured as IPv4 or IPv4&IPv6.
network.secondary_dns = 4.2.2.2
Matrix SPARSH VP110 User Guide 469