Toyota 1996 LAND CRUISER User Manual page 1366

1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
TRANSFER
(c)
SST
NOTICE:
Before pressing, align the holes on the bushing and shaft
so that the pin on the shaft aligned with the cutting portion
of the bushing.
Q00546
11.
HINT:
Make sure to install the high and low clutch sleeve in the correct
direction.
12.
(a)
(b)
Q00555
13.
Using SST and a press, install the front taper roller bearing.
SST
SST
Q00539
14.
Using SST and a press, install the front drive gear piece.
SST
SST
Q00540
15.
(a)
Mark
A
B
C
D
E
TF0931
F
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− CENTER DIFFERENTIAL
Using SST and a press, install the high speed output gear
bushing.
SST 09316−12010, 09316−60011 (09316−00011)
INSTALL HIGH AND LOW CLUTCH SLEEVE
INSTALL HIGH SPEED OUTPUT GEAR AND NEEDLE
ROLLER BEARING
Apply gear oil to the needle roller bearing.
Install the high speed output gear and needle roller bear-
ing.
INSTALL FRONT TAPER ROLLER BEARING
SST 09316−12010, 09316−60011 (09316−00011)
INSTALL FRONT DRIVE GEAR PIECE
SST 09316−12010, 09316−60011 (09316−00011)
INSTALL SNAP RING
Select a snap ring that will allow minimum axial play.
Thickness mm (in.)
2.00 (0.0787)
2.10 (0.0827)
2.20 (0.0866)
2.30 (0.0906)
2.40 (0.0945)
2.50 (0.0984)
TR−23
Mark Thickness mm (in.)
G 2.60 (0.1024)
H 2.70 (0.1063)
J 2.80 (0.1102)
K 1.80 (0.0709)
L 1.90 (0.0748)
− −