Toyota 1996 LAND CRUISER User Manual page 1130

SA−68
Brass Bar
Positions
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE −
REPLACEMENT
1. REMOVE OIL SEAL AND INNER BEARING
(a) Using SST, remove the oil seal.
SST
(b) Remove the inner bearing from the hub.
2. REMOVE BEARING OUTER RACE
Using a brass bar and hammer, remove the bearing outer
races.
NOTICE:
Be careful not to damage the ABS speed sensor rotor.
R13157
3. INSTALL BEARING OUTER RACE
Outside race:
S
SST
Using SST and a press, install new bearing outer races.
SST
Inside race:
S
Using SST and a press, install new bearing outer races.
SST
R13158
4. PACK BEARINGS WITH MP GREASE
(a) Place MP grease on the palm of your hand.
(b) Pack grease into the bearing until the grease ooze out
from the other side.
(c) Do the same around the bearing circumference.
5. COAT INSIDE OF HUB WITH MP GREASE
R13159
6. INSTALL INNER BEARING AND OIL SEAL
(a) Place inner bearing into the hub.
(b) Using SST, install a new oil seal into the hub.
SST
(c) Apply MP grease to the oil seal lip.
Brought to you by BirfMark
Version 1.00 - 12/21/2010
REAR AXLE HUB
09308−00010
09950−60020 (09951−00710),
09950−70010 (09951−07150)
09950−60020 (09951−00810),
09950−70010 (09951−07150)
09223−15020, 09950−70010 (09951−07150)
SA1VA−01