Toyota 1996 LAND CRUISER User Manual page 1279

Tape
Screwdriver
Press
Bearing
REMOVE
SST
Socket
Press
Wrench
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
STEERING
5.
(a)
NOTICE:
To prevent vane pump shaft damage, wind tape on the
shaft.
SR4528
(b)
(c)
(d)
NOTICE:
Be careful not to damage the shaft.
(e)
INSTALL
R13761
6.
Press
(a)
Oil Seal
NOTICE:
Be careful not to damage the housing.
R08077
(b)
(c)
NOTICE:
A
S
S
A 3.4 mm
(+ 3mm)
W03071
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− POWER STEERING VANE PUMP
IF NECESSARY, REPLACE BEARING
Using 2 screwdrivers, remove the snap ring from the vane
pump shaft.
Using a press, press out the bearing.
Coat a new bearing with power steering fluid.
Using a press, press in the bearing.
Install a new snap ring to the shaft.
IF NECESSARY, REPLACE OIL SEAL
Using a screwdriver and hammer, tap out the oil seal from
the front housing.
Coat a new oil seal lip with power steering fluid.
Using a socket wrench (23 mm), press in the oil seal as
shown in the illustration.
Make sure you install the oil seal facing the correct
direction.
Be careful not to damage the front housing.
SR−29