Toyota 1996 LAND CRUISER User Manual page 1108

SA−46
Actuator Installation
Hole
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE
(j)
(k)
(l)
(m)
R13413
31.
Measure distance between the sleeve and tip of the differential
case when differential is free and locked.
R08152
32.
Install the indicator switch with a new gasket.
SA1993
33.
(a)
Outside
Shift Fork
R08153
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− FRONT DIFFERENTIAL CARRIER
Install the ball, compression spring and spring seat.
Clean the threads of 2 plugs and plug holes with toluene
or trichloroethylene.
Apply adhesive to the plug threads.
Adhesive: Part No. 08833−00080, THREE BOND 1344,
LOCTITE 242 or equivalent
Using a hexagon wrench, install and tighten the screw
plugs.
Torque: 22 N·m (220 kgf·cm, 16 ft·lbf)
w/ DIFFERENTIAL LOCK:
MEASURE DISTANCE BETWEEN SLEEVE AND DIF-
FERENTIAL CASE END SIDE
Standard distance:
LOCK: 17.44 − 18.86 mm (0.6866 − 0.7425 in.)
FREE: 32.40 − 33.90 mm (1.2756 − 1.3346 in.)
w/ DIFFERENTIAL LOCK:
INSTALL INDICATOR SWITCH
Torque: 40 N·m (410 kgf·cm, 30 ft·lbf)
w/ DIFFERENTIAL LOCK:
INSTALL ACTUATOR
Check that the outermost rack tooth of the shift fork is
virtually above the center line of the actuator installation
hole.