Toyota 1996 LAND CRUISER User Manual page 1270

SR−20
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
STEERING − TILT STEERING COLUMN
11. INSTALL STEERING WHEEL
(a) Align the matchmarks on the wheel and main shaft as-
sembly.
(b) Torque the wheel set nut.
Torque: 34 N·m (350 kgf·cm, 25 ft·lbf)
(c) Connect the connector.
12. INSTALL STEERING WHEEL PAD
NOTICE:
Make sure the wheel pad is installed to the specified
torque. If the wheel pad has been dropped, or there are
cracks, dents or other defects in the case or connector, re-
place the wheel pad with a new one. When installing the
wheel pad, take care that the wirings do not interfere with
other parts and are not pinched between other parts.
(a) Connect the airbag connector.
(b) Install the wheel pad after confirming that the circumfer-
ence groove of the torx screws is caught on the screw
case.
(c) Using a torx socket wrench, torque the 2 screws.
Torque: 9.0 N·m (90 kgf·cm, 78 in.·lbf)
(d) Install the steering wheel lower No.2 and No.3 cover.
13. CHECK STEERING WHEEL CENTER POINT
Brought to you by BirfMark
Version 1.00 - 12/21/2010