Toyota 1996 LAND CRUISER User Manual page 1018

PR−4
Matchmarks
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
PROPELLER SHAFT − PROPELLER SHAFT ASSEMBLY
INSPECTION
1. INSPECT FRONT AND REAR PROPELLER SHAFTS
FOR DAMAGE OR RUNOUT
Using a dial indicator, check the runout of shafts.
Maximum runout: 0.8 mm (0.031 in.)
If shaft runout is greater than maximum, replace the shaft.
PR0310
2. REMOVE SLEEVE YOKE FROM PROPELLER SHAFT
Place matchmarks on the sleeve yoke and shaft.
(1) Pull out the sleeve yoke from the shaft.
(2) Remove the dust cover from the shaft.
PR0014
3. INSPECT SPIDER BEARING
Check the spider bearings for wear or damage.
S
Check the spider bearing axial play by turning the yoke
S
with holding the shaft tightly.
Bearing axial play: Maximum 0.05 mm (0.0020 in.)
If necessary, replace the spider bearing.
4. INSERT SLEEVE YOKE INTO PROPELLER SHAFT
(a) Apply MP grease to the propeller shaft spline and sleeve
yoke sliding surface.
PR0056
(b) Align the matchmarks on the sleeve yoke propeller shaft.
(c) Install the propeller shaft into the sleeve yoke.
Brought to you by BirfMark
Version 1.00 - 12/21/2010
PR06Q−01