Toyota 1996 LAND CRUISER User Manual page 1101

Rear Front
SST
SST
SST
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE
7.
(a)
(b)
(c)
SA2465
8.
Using SST and a hammer, install a new oil storage ring.
SST
SA2406
9.
S
S
SA2203
10.
(a)
SST
(b)
FA2042
11.
(a)
HINT:
Assemble the spacer and oil seal after adjusting the gear con-
tact pattern.
(b)
R13140
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− FRONT DIFFERENTIAL CARRIER
CHECK RING GEAR RUNOUT
Install the differential case onto the carrier and tighten the
adjusting nut just to where there is no play in the bearings.
Using a dial indicator, check the ring gear runout.
Maximum runout: 0.10 mm (0.0039 in.)
Remove the differential case.
INSTALL OIL STORAGE RING
SST 09316−60011 (09316−00011, 09316−00021)
INSTALL DRIVE PINION FRONT AND REAR BEARING
OUTER RACES
Front side:
Using SST and a press, install the 2 outer races.
SST 09316−60011 (09316−00011, 09316−00051)
Rear side:
Using SST and a press, install the 2 outer races.
SST 09316−60011 (09316−00011, 09316−00021)
INSTALL DRIVE PINION FRONT BEARING
Install the plate washer on the drive pinion with the cham-
fered end facing the pinion gear.
Using SST and a press, install the front bearing onto the
drive pinion.
SST 09506−30012
TEMPORARILY ADJUST DRIVE PINION PRELOAD
Install the drive pinion, rear bearing and oil slinger.
Install the companion flange with SST.
SST 09550−30010 (09951−03010, 09953−03010,
09954−03010, 09955−03030, 09956−03020)
SA−39