Toyota 1996 LAND CRUISER User Manual page 1107

Holes
Groore
FIPG Width Approx.
1 − 2 mm (0.04 − 0.08 in.)
Adhesive
Lock
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE −
30. w/ DIFFERENTIAL LOCK:
INSTALL SHIFT FORK SHAFT
(a) Apply MP grease onto the outer circuit of the fork shaft.
(b) Install the fork shaft to match the hole of the shift fork and
that of the shift fork shaft.
SA2417
(c) Remove any FIPG material and be careful not to drop oil
on the contacting surface of the differential carrier and
shaft retainer.
(d) Apply FIPG to the carrier, as shown.
FIPG: Part No. 08826−00090, THREE BOND 1281 or
equivalent
HINT:
Install the shaft retainer within 10 minutes after applying FIPG.
Z15179
(e) Clean the threads of the bolts and retainer bolts holes with
toluene or trichlorethylene.
(f) Apply adhesive to 2 or 3 threads of the mount bolt end.
Adhesive: Part No. 08833−00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(g) Tighten the shaft retainer with the 2 bolts.
Torque: 24 N·m (240 kgf·cm, 17 ft·lbf)
Z10101
(h) Using a pin punch and hummer, install the slotted spring
pin to the shift fork.
SA2205
(i) Shift the fork deeply and keep the differential lock condi-
tion.
SA1979
Brought to you by BirfMark
Version 1.00 - 12/21/2010
FRONT DIFFERENTIAL CARRIER
SA−45