Toyota 1996 LAND CRUISER User Manual page 1151

Boiling Water
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE −
(d) Using a torx socket wrench, torque the 5 bolts and 3 pin-
ion shaft pins.
Torque: 58 N·m (590 kgf·cm, 43 ft·lbf)
4. INSTALL SIDE BEARINGS
(a) w/o Differential lock:
Using SST and a press, install the 2 side bearings on the
differential case.
SST
(b) w/ Differential lock:
Using SST and a press, install the 2 side bearings on the
differential case.
SST
5. INSTALL RING GEAR ON DIFFERENTIAL CASE
(a) Clean the contact surfaces of the differential case and
ring gear.
(b) Heat the ring gear to about 100°C (212°F) in boiling wa-
ter.
(c) Carefully remove the ring gear from the boiling water.
(d) After the moisture on the ring gear has completely evapo-
rated, quickly install the ring gear to the differential case.
SA1143
(e) Align the matchmarks on the ring gear and differential
case.
(f) Temporarily install the set bolts and nuts so that the bolt
holes in the ring gear and differential case are not misa-
ligned.
NOTICE:
Install the bolts so that the tapered part of the bolt is on the
ring gear side. The ring gear set nuts should not tighten un-
til the ring gear has cooled sufficiently.
Brought to you by BirfMark
Version 1.00 - 12/21/2010
REAR DIFFERENTIAL CARRIER
09315−00022, 09550−10012 (09558−10010)
09550−60010, 09550−10012 (09558−10010)
SA−89