Toyota 1996 LAND CRUISER User Manual page 1152

SA−90
Front Rear
SST
SST
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE
(g)
6.
(a)
(b)
(c)
7.
SST
(a)
(b)
SA2425
8.
(a)
HINT:
First fit a washer with the same thickness as the washer which
was removed, then after checking the tooth contact pattern, re-
place the washer with one of a different thickness if necessary.
SST
(b)
SA3102
9.
(a)
HINT:
Assemble the spacer and oil seal after adjusting the gear con-
tact pattern.
(b)
(c)
R13414
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− REAR DIFFERENTIAL CARRIER
After the ring gear cools down enough, tighten the set
bolts uniformly and a little at a time.
Torque: 110 N·m (1,125 kgf·cm, 81 ft·lbf)
CHECK RING GEAR RUNOUT
Install the differential case onto the carrier and tighten the
adjusting nut just to where there is no play in the bearings.
Using a dial indicator, check the ring gear runout.
Maximum runout: 0.10 mm (0.0039 in.)
Remove the differential case.
INSTALL DRIVE PINION FRONT AND REAR BEARING
OUTER RACES
Front side:
Using SST and a press, install the 2 outer races.
SST 09950−60020 (09951−00710),
09950−70010 (09951−07150)
Rear side:
Using SST and a press, install the 2 outer races.
SST 09950−60020 (09951−00890),
09950−70010 (09951−07150)
INSTALL DRIVE PINION REAR BEARING
Install the washer on the drive pinion.
Using SST and a press, install the rear bearing onto the
drive pinion.
SST 09506−35010
TEMPORARILY ADJUST DRIVE PINION PRELOAD
Install the drive pinion and front bearing.
Install the oil slinger.
Install the companion flange with SST.
SST 09550−30010 (09951−03010, 09953−03010,
09954−03010, 09955−03030, 09956−03020)