Toyota 1996 LAND CRUISER User Manual page 1102

SA−40
SST
MP Grease
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE −
(c) Adjust the drive pinion preload by tightening the compan-
ion flange nut.
Using SST to hold the flange, tighten the nut.
SST
NOTICE:
As there is no spacer, tighten a little at a time, being careful
not to overtighten.
SA2401
(d) Using a torque wrench, measure the preload.
Preload (at starting):
New bearing
0.9 − 1.6 N·m (10 − 16 kgf·cm, 8.7 − 13.9 in.·lbf)
Reused bearing
0.5 − 0.8 N·m (5 − 8 kgf·cm, 4.3 − 6.9 in.·lbf)
HINT:
Measure the total preload after first turning the bearing clock-
wise and counterclockwise several times to mark the bearing
SA2403
smooth.
12. w/o DIFFERENTIAL LOCK:
INSTALL DIFFERENTIAL CASE IN CARRIER
(a) Place the bearing outer races on their respective bear-
ings. Make sure the left and right outer races are not inter-
changed.
(b) Install the case in the carrier.
HINT:
Make sure that there is backlash between the ring gear and
drive pinion.
13. w/ DIFFERENTIAL LOCK:
INSTALL DIFFERENTIAL CASE IN CARRIER
(a) Apply MP grease on the rack of the shift fork and connect-
ing part of the indicator switch.
(b) Insert the shift fork into the differential carrier, as shown.
SA2161
(c) Install outer races, adjusting nuts and left side to sleeve.
HINT:
Check that the sleeve moves smoothly.
(d) Install the shift fork in the groove of the sleeve holding it
by hand and install the case in the carrier.
HINT:
Make sure that there is backlash between the ring gear and
drive pinion.
Z10100
Brought to you by BirfMark
Version 1.00 - 12/21/2010
FRONT DIFFERENTIAL CARRIER
09330−00021