Toyota 1996 LAND CRUISER User Manual page 1171

Actuator Installation
Hole
3 2
50°
108°
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE
INSTALLATION
1.
(a)
Outside
Shift Fork
Z07259
(b)
NOTICE:
S
1.5
S
S
Matchmark
(Groove)
R08154
(c)
(d)
(e)
SA2306
(f)
HINT:
Do not damage the O−ring of the actuator.
SA2420
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− DIFFERENTIAL LOCKING SYSTEM
INSTALL FRONT ACTUATOR
Check that the outermost rack tooth of the shift fork is
virtually above the center line of the actuator installation
hole.
Using a dry cell battery, align the matchmark on the pinion
with the center line of the actuator.
If the pinion of the actuator is not in the specified
place, the actuator is difficult to be installed.
Do not supply the battery positive voltage between
terminals.
If the matchmark comes to the extension limit of the
rotation, do not electrify moreover.
Install a new O−ring to the actuator.
Apply a light coat of gear oil on the O−ring.
Apply MP grease to the gear part of the actuator.
Install the actuator to the differential with the 2 nuts and
bolt, so that the outermost rack tooth of the shift fork will
fit matchmark of the pinion of the actuator.
Torque: 26 N·m (270 kgf·cm, 20 ft·lbf)
SA−109
SA1VO−02