Toyota 1996 LAND CRUISER User Manual page 1095

Matchmarks
SST
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE
18. REMOVE RING GEAR
(a) Using a screwdriver and hammer, unstake the lock plate.
(b) Place matchmarks on the ring gear and differential case.
(c) Remove the ring gear 10 set bolts and 5 lock plates.
(d) Using a plastic hammer, tap on the ring gear to separate
it from the differential case.
Z15178
19. CHECK DIFFERENTIAL CASE RUNOUT
(a) Install the differential case in the differential carrier and
tighten the adjusting nut just to where there is no play in
the bearing.
(b) Using a dial indicator, measure the differential case run-
out.
Maximum case runout: 0.07 mm (0.0028 in.)
(c) Remove the differential case.
SA2464
20. REMOVE SIDE BEARING FROM DIFFERENTIAL
CASE
Using SST, pull the side bearing from the differential case.
SST
HINT:
Fix the claws of SST to the notches in the differential case.
W03472
21. w/o DIFFERENTIAL LOCK:
DISASSEMBLE DIFFERENTIAL CASE
(a) Using a pin punch and hammer, remove the straight pin.
(b) Remove these parts from the differential case:
S
S
S
S
S
RA0997
22. w/ DIFFERENTIAL LOCK:
DISASSEMBLE DIFFERENTIAL CASE
(a) Place matchmarks on the LH and RH cases.
(b) Remove the 8 bolts uniformly, a little at a time.
(c) Using a plastic hammer, separate the LH and RH cases.
(d) Remove these parts from the RH differential case:
Matchmarks
S
S
S
FA2046
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− FRONT DIFFERENTIAL CARRIER
09950−40010 (09951−04010, 09952−04020,
09953−04020, 09954−04010, 09955−04010,
09957−04010, 09958−04010),
09950−60010 (09951−00480)
Pinion shaft
2 Pinion gears
2 Pinion gear thrust washers
2 Side gears
2 Side gear thrust washers
2 Side gears
2 Side gear thrust washers
Spider
SA−33