Toyota 1996 LAND CRUISER User Manual page 1159

SST
SST
SST
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE −
22. INSTALL OIL SEAL
(a) Using SST and a hammer, install a new oil seal, as shown.
SST
Oil seal drive in depth: 1.0 mm (0.039 in.)
(b) Apply MP grease to the oil seal lip.
SA2454
23. INSTALL COMPANION FLANGE
(a) Install the companion flange with SST.
SST
(b) Install the plate washer and a new nut.
HINT:
Coat the threads of a new nut with gear oil.
R13414
(c) Using SST to hold the flange, tighten the nut.
SST
Torque: 245 N·m (2,500 kgf·cm, 181 ft·lbf)
SA2351
24. ADJUST DRIVE PINION PRELOAD
Using a torque wrench, measure the preload of the backlash
between the drive pinion and ring gear.
Preload (at starting):
New bearing
1.3 − 2.0 N·m (13 − 20 kgf·cm, 11.3 − 17.4 in.·lbf)
Reused bearing
0.7 − 1.0 N·m (7 − 10 kgf·cm, 6.1 − 8.7 in.·lbf)
If the preload is greater than the specification, replace the bear-
SA2446
ing spacer.
If the preload is less than the specification, retighten the nut a
little at a time 13 N·m (130 kgf·cm, 9 ft·lbf) until the specified pre-
load is reached.
Maximum torque: 441 N·m (4,500 kgf·cm, 326 ft·lbf)
If the maximum torque is exceeded while retightening the nut,
replace the bearing spacer and repeat the preload procedure.
Do not back off the pinion nut to reduce the preload.
Brought to you by BirfMark
Version 1.00 - 12/21/2010
REAR DIFFERENTIAL CARRIER
09214−76011
09550−30010 (09951−03010, 09953−03010,
09954−03010, 09955−03030, 09956−03020)
09330−00021
SA−97