Toyota 1996 LAND CRUISER User Manual page 1172

SA−110
FIPG Width Approx.
1 − 2 mm (0.04 − 0.08 in.)
Adhesive
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE −
(g) Connect the connector and tube.
HINT:
The depth of the insertion of the bleeder tube into the
S
hose is approx. 15 mm (0.59 in.).
Take care that water or the equivalent will not adhere to
S
the connector and hose.
(h) Cancel the front differential lock.
With the ignition switch ON, turn the differential lock con-
trol switch to OFF to cancel the differential lock.
2. INSTALL REAR ACTUATOR
(a) Clean contacting surfaces of any FIPG material using
gasoline or alcohol.
(b) Apply FIPG to the actuator.
FIPG: Part No. 08826−00090, THREE BOND 1281 or
equivalent
HINT:
Install the actuator within 10 minutes after applying FIPG.
Z15220
(c) Install the actuator to the differential and match the shaft
with the shaft fork hole.
(d) Clean the threads of the set bolt and shaft fork with the
white gasoline.
(e) Coat the threads of the set bolt with adhesive.
Adhesive: Part No. 08833−00070, THREE BOND 1324
or equivalent
(f) Tighten the shift fork set bolt.
Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)
Z07262
(g) Tighten the 4 bolts uniformly, a little at a time.
Torque: 24 N·m (240 kgf·cm, 17 ft·lbf)
SA2620
(h) Install the cover.
(1)
(2)
FIPG: Part No. 08826−00090, THREE BOND 1281 or
equivalent
HINT:
Install the cover within 10 minutes after applying FIPG.
Brought to you by BirfMark
Version 1.00 - 12/21/2010
DIFFERENTIAL LOCKING SYSTEM
Clean the contacting surfaces of any FIPG material
using gasoline or alcohol.
Apply FIPG to the cover.