1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
SUSPENSION AND AXLE
−
REMOVAL
REMOVE REAR AXLE SHAFT
(a)
Remove the 6 set nuts and plate washers.
Torque: 34 N·m (340 kgf·cm, 25 ft·lbf)
(b)
Using a brass bar and hammer, strike the center part of
the axle shaft to remove the 6 cone washers.
(c)
Install and gradually tighten 2 bolts evenly and pull the
axle shaft.
(d)
Remove the 2 bolts from the rear axle shaft.
(e)
Remove the rear axle shaft and gasket.
NOTICE:
Be careful not to damage the oil seal.
Brought to you by BirfMark
Version 1.00 - 12/21/2010
REAR AXLE SHAFT
SA−63
SA1V5−01