Toyota 1996 LAND CRUISER User Manual page 1267

"A"
Mark
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
STEERING − TILT STEERING COLUMN
7. INSTALL 2 TILT PAWLS
(a) Coat the collar with molybdenum disulfide lithium base
grease and install it to the tilt pawl.
(b) Install the pawl.
HINT:
Install the pawl pin into the long hole of the tilt lever/ tilt sub lever.
(c) Install the bolt through the pawls and tilt lever assembly.
(d) Temporarily install the 2 washers and nut.
(e) Torque the tilt lever assembly set bolt.
Torque: 2.9 N·m (30 kgf·cm, 26 in.·lbf)
8. ENGAGE AND ADJUST 2 TILT PAWLS
(a) Engage the tilt sub lever side pawl to the center of the
ratchet.
(b) While turning the tilt lever side tilt pawl collar, completely
engage the tilt lever side pawl to the ratchet.
(c) Torque the nut.
Torque: 5.9 N·m (60 kgf·cm, 52 in.·lbf)
9. SELECT AND INSTALL 2 TILT PAWL STOPPERS
(a) With the tilt pawl and ratchet engaged, install the stopper.
(b) Check that the alignment marks on the stopper and pawl
align when the stopper is rotated to the pawl side.
(c) If the alignment marks do not align, select stopper accord-
"A"
ing to the following table.
Tilt lever side
1
2
SR3128
3
4
5
(d) After selecting the stoppers, check that on both sides the
pawl and ratchet are fully engaged.
10. INSTALL 2 TILT LEVER RETAINERS
(a) Install a new E−ring.
(b) Torque the nut.
Torque: 15 N·m (150 kgf·cm, 11 ft·lbf)
Brought to you by BirfMark
Version 1.00 - 12/21/2010
Dimension "A"
Tilt sub lever side
12.65 − 12.75
A
(0.4980 − 0.5020)
12.55 − 12.65
B
(0.4941 − 0.4980)
12.45 − 12.55
C
(0.4902 − 0.4941)
12.35 − 12.45
D
(0.4862 − 0.4902)
12.25 − 12.35
E
(0.4823 − 0.4862)
SR−17
mm (in.)