Routing (Static Routing); Figure 1-27: Access Control - Allied Telesis AT-AR256E Reference Manual

2. You can select a IP from the IP Access List or enter a New IP and check Add
3. Change the LAN and/or WAN configurations
4. Click on the Apply button
5. Click Save Settings

Routing (Static Routing)

5.5.15
If the AT-AR256E is connected to more than one network, you may need to set up a static route
between them. A static route is a predefined pathway that network information must travel to
reach a specific host or network. You can use Static Routing to allow different IP domain users
to access the Internet through the AT-AR256E.
The New Destination IP is the address of the remote LAN or host to which you want to assign a
static route. Enter the IP address of the host for which you wish to create a static route here. For
a standard Class C IP domain, the network address is the first three fields of the New Destination
IP, while the last field should be 0. The Mask identifies which portion of a IP address is the
network portion and which is the host portion.
255.255.255.0. The Gateway should be the IP address of the routing device that allows for
contact between the Gateway and the remote network or host. The Metric indicates the cost of
using the routes in the Routing Table that are derived from the interface configuration and
becomes the value in the Metric column for those routes in the IP routing table. If there are
multiple closest matching routes to a destination in the IP routing table, the route with the lowest
metric is used.
See Figure 1-28
Reference Manual

Figure 1-27: Access Control

For a full Class C subnet, the Mask is
Reference Manual Page 31 of 40