Toshiba DP120F Service Manual page 89

1.2.17 Redial Mode
This setting is performed to select the automatic redial interval and specify the number redial
attempts to be made when communication is not completed properly because the line is busy or
a communication error occurs.
Use the [ ↑ ] or [ ↓ ] keys to select one of the two options (INTERVAL and COUNTER),
(1)
then press the [ENTER] key.
REDIAL MODE
01.INTERVAL
02.COUNTER
When "01.INTERVAL" is selected, the screen below is displayed. Enter a value from 01 to
15 (in units of minutes) as the redial interval, then press the [ENTER] key.
<Remarks>
When "02.COUNTER" is selected, the screen below is displayed. Enter 00 to 14 as the
counter value, then press the [ENTER] key. When "0" is entered, no redialing will occur.
<Remarks>
(2) After the "OPERATION COMPLETED" message is displayed, press the [STOP] key to
return to the Standby Mode screen.
March 2000 © TOSHIBA TEC
When any value outside the specified range is entered, it must be set again.
REDIAL MODE
INTERVAL =(01-15MIN)
When any value outside the specified range is entered, it must be set again.
REDIAL MODE
COUNTER =(00-14)
[MENU], [4], [1], [14]
01
02
4-23 DP120F/DP125F Function Settings