Toshiba DP120F Service Manual page 628

1.5 FUNCTION TEST
(* The keystrokes given reflect continuous Service Mode operation, they will vary slightly for
single use operation.)
The FUNCTION TEST Mode is used to check various functions of this machine.
01.OPE. PANEL TEST
02.PRINT TEST
03.MODEM TEST
04.SENSOR TEST
<Remarks>
1.5.1 OPE. PANEL TEST
This test is used to check the LCD, LED and scanner LED array, and each key on the Opera-
tion panel.
Use the [ ↑ ] or [ ↓ ] key to select the "01. OPE. PANEL TEST", and then press the
(1)
[ENTER] key.
(2) All the LED's are lit. Check that each LED turns on and off normally. All the dots of the LCD
is turn on and off.
(3) Press the [START] key, and "S" will appear on the display and the cursor automatically will
move upper left to lower right. Check if the LCD display is normal.
Press the [START] key
(4) Press all the keys except the [STOP] key, and the status of each key will be displayed.
DP120F/DP125F Troubleshooting
05.SRAM TEST
06.DRAM TEST
07.CLOCK IC TEST
↓
08.SCANNER TEST
"10. NET. BOARD TEST" and "11. PCL BOARD TEST" are displayed only
when the GF-1010 (Optional NIC) and GA-1020 (Optional PCL board) are
installed, respectively.
S
← Pressing key status (When [#] key pressed)
#
[MENU], [9], [4]*
↓
[MENU], [9], [4], [01]
←→
_
→
11-16
08.SCANNER TEST
09.CODEC TEST
10.NET. BOARD TEST
11.PCL BOARD TEST
_
March 2000 © TOSHIBA TEC