Toshiba DP120F Service Manual page 642

1.6.3 MEMORY WRITE
This setting is used to change the contents of a specific backup RAM address (using a 6-digit
HEX code). Enter the desired address from the dial keypad, and then press the [ENTER] key.
The address is incremented by pressing the [ENTER] key.
WARNING: Under normal circumstances it is not necessary to make changes to
Use the [ ↑ ] or [ ↓ ] key to select "03.MEMORY WRITE," and then press the [ENTER] key.
(1)
MEMORY WRITE
ADDRESS =
(2) Enter the desired 6-digit address for inputting data, and then press the [ENTER] key.
MEMORY WRITE
ADDRESS =XXXXXX
DATA =
<Remarks>
<Remarks>
(3) Enter the data, and then press the [ENTER] key.
MEMORY WRITE
ADDRESS =XXXXXX
DATA =
(4) The screen then increments to the next address. After setting, press the [STOP] key to
return to the standby mode screen.
DP120F/DP125F Troubleshooting
the memory write addresses. It is recommended that changes to these
settings be made only in response to a specific instruction from a
Toshiba service representative, service bulletin, or other publication.
YY
To enter the value, use the following keys,
0 to 9: Dial keys
A to F: One touch key 01 to 06
Be sure to enter the address in the range from 000000 to FFFFFF in HEX
code.
ZZ
[MENU], [9], [5], [03]
11-30 March 2000 © TOSHIBA TEC